Arduino Bluetooth controle Basishandleiding (4 / 5 stap)

Stap 4: Arduino Sketch

int ledblue = 2;

int tx = 1;

int rx = 0;

char inSerial [15];

void setup {Serial.begin(9600);

pinMode (ledblue, OUTPUT);

pinMode (tx, OUTPUT);

pinMode (rx, INPUT);

allpinslow();

}

void loop

{int i = 0;

int m = 0;

delay(500);

Als (Serial.available() > 0) {terwijl (Serial.available() > 0) {inSerial[i]=Serial.read();

i ++; }

inSerial [i] = '\0';

Check_Protocol(inSerial); }}

VOID allpinslow() {digitalWrite (ledblue, hoge);

digitalWrite (ledblue, laag); } void Check_Protocol (char inStr[]) {int i = 0;

int m = 0;

Serial.println(inStr);

if(!strcmp(inStr,"2off")) {//Led Off allpinslow();

digitalWrite (ledblue, laag); Serial.println ("Blue af");

voor (m = 0; m < 11; m ++) {inStr [m] = 0;} ik = 0;} if(!strcmp(inStr,"2on")) {//Led op allpinslow();

digitalWrite (ledblue, hoge);

Serial.println ("Blue op"); voor (m = 0; m < 11; m ++) {inStr [m] = 0;} ik = 0;} else {voor (m = 0; m < 11; m ++) {inStr [m] = 0;} ik = 0;

}}